Seca 201_inch Manual de usuario descargar pdf (Pagina 12)

12 •

ATTENTION!

Malfunction due to installation errors

If no spacer washers are used, the head slide

will be trapped against the wall. This will make it

impossible to measure height.

 Ensure that at least 1 spacer washer per

screw is used.

3. Put the appropriate number of spacer washers rea-

dy:

– 1 spacer washer = 1.2 cm

– Every subsequent spacer washer: + 0.7 cm

– 5 spacer washers = 4.0 cm

4. Pull the upper telescopic element out to the 173 cm

mark.

The holes in the lower telescopic element are expo-

sed.

5. Put a screw in the top bore of the measuring rod.

6. Put the appropriate number of spacer washers on

the screw (the illustration shows attachment option

II).

7. Screw measuring rod to wall hand-tight.

8. Repeat steps 5. to 7. for the bottom bore.

9. Tighten up both screws fully.

173 cm

max = 4,0 cm

max = 5

min = 1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

Seca 201_inch Manual de usuario Pagina 12