Seca 763 printer-module Manual de usuario descargar pdf (Pagina 11)

Weighing with printout

– Switch the scale on if necessary.

– Switch on the printer at the on/off

switch.

– Get the patient to stand on the scale.

The patient should then stand still. The

measured weight is printed out.

– If you also want to measure height

(models 763/764 only), perform a

measurement (see "Measuring height”

in the operating instructions for the

scale).

Then press the Data Valid key. The

height and calculated BMI value are

then printed out.

– When the load is removed from the

scale, date and time are also printed.

Then tear off the printout towards the

tearing edge.

Note:

If the printout is in 12-hour format,

morning times are marked AM and af-

ternoon times PM.

– If you do not require any further print-

out, switch the printer off again at the

on/off switch.

What do I do if ...

… the scale switches off when attempting to print?

– Too weak a mains power unit is connected. Connect seca mains power unit

68-32-10-263 supplied (see “Connecting the scale” on page 8).

… the printer does not print during weighing?

– Is the printer switched on?

– Is the flap of the paper dispenser completely closed?

…

PAPEr appears in the display?

– The paper is finished. Insert a new roll.

– Is the flap of the paper dispenser closed?

… the printer prints during weighing, but there is nothing to be seen on the paper?

– The paper has been put in the wrong way round. Insert the roll the right way round.

on/off switch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 71 72

Sin comentarios

Seca 763 printer-module Manual de usuario Pagina 11