Seca 515 Manual de usuario descargar pdf (Pagina 31)

Operation • 31

English

7.3 Performing bioelectric impedance analysis (BIA)

Switching on the device 1. Ensure that the device has no load.

2. Press the ON/OFF button.

The start screen appears.

The

weight/height tab is active.

Determining the weight and height ♦ Determine the weight and height as described in section „Determining

the weight and height“ from page 27.

Checking the module selection

1. Activate the bia tab.

The bioelectric impedance analysis is available when the message

“Self-test running” is no longer displayed.

The module selection dialog window appears. All modules are

activated in the factory (except raw data for impedance).

NOTE:

If the module selection does not appear, the function “Show the

module selection at the start of the measurement procedure” is

deactivated in the

settings menu. You can reactivate this function

or check the module selection directly in the

settings menu (see

“Configuring device” on page 61).

2. Check the module selection.

3. Deactivate modules for which no measurements are to be

performed.

NOTE:

• If you activate the

Raw data for impedance module, the duration of

the BIA measurement is extended. Activate the

Raw data for

impedance

module if you wish to use the measured results for

scientific studies. The impedance data for up to 19 frequencies

are available in the analysis tab.

• If you deactivate the

Energy evaluation module, there is no

request for the Physical Activity Level (PAL) following a BIA

measurement.

4. Press the

continue button.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 81 82

Sin comentarios

Seca 515 Manual de usuario Pagina 31